Artificial
Grass 
Installations
Guide
Installation
Guide
•
Read these directions before installation.
Call 1-866-326-2554 with any questions.
Eco Alliance Waterless Grass shall
not be liable for any incidental
or consequential losses, damages,
or expenses directly or indirectly
arising from the sale, handling,
or use of its products. No representations
or warranties are made regarding
this installation guide nor are
any results guaranteed by utilizing
this installation guide.
As with any home improvement,
proper installation is required
to achieve high quality visual
results. Installation will take
approximately 2 days depending
on the size of the installation
area. The optimal temperature
to install Eco Alliance Waterless
Grass is 50 degrees Fahrenheit
and above.
•
Measure
Measure the length and width
of the installation area in feet.
Eco Alliance Waterless Grass comes
in 13’ widths; lengths are
cut to your measurements up to
130’. The grass can be seamed
together to create greater widths.
The grass must be installed with
the grain facing the same direction,
preferably facing the viewer’s
perspective. Determine the most
efficient way to utilize 13’
sections with the fewest amounts
of seams. Allow extra grass for
seams and trimming. Add the 13’
sections. This will give you the
total amount of square feet needed
to determine price and the amount
of materials required. Measure
twice before ordering. Example:
Section 1: 13 ft. X 35 ft. = 455
sq. ft., Section 2: 13 ft. X 25
ft. = 325 sq. ft., Add 455 sq.
ft. to 325 sq. ft. for a total
of 780 sq. ft.
•
Prior to Installation
•Call your local utility
department to survey the installation
area.
• If an irrigation system
exists, contact an irrigation
company to have it capped off.
• Use your sample piece
of grass to practice the seaming
process.
• Determine the amount of
materials you will need.
•
Day of Installation
• Roll the grass out on
a clean, flat surface. Allow the
grass to lay in direct sunlight
for 2 hours prior to installation.
• Gather all necessary tools
and place the adhesive container
in direct sunlight.
•
Step 1: Prepare the Base
•Step
2: Install the Grass
•Step
3: Infill the Grass
|
